This kit is simple and easy to use. Comes with all the electronics and mechanical parts needed to build your very own DIY Engine DYNO.

This product is still in testing and is expected to cost under $2,000. Please fill out the form below to tell us more about what engines you want to test and to sign up to be notified when it’s up for sale.

How it works.

1) We provide the electronics so you don’t have to figure that out. Sensors, computer and instructions will be provided.

2) Adapter plates and rubber drive shaft coupler are provided for the engine you work with. Just bolt it on.

3) Axle for the load is something you need to find locally. Junk yards and used listing work well.

Any 3500 truck axle will do up to 500 hp. Anything above that and semi axles would be a good choice but upgrades to the 3500 axle will help you get more out of your DIY Engine DYNO.

The rest is up to you. The frame, cooling system and other necessities to run the engine will need to be figured out by you for your needs. We pulled all the parts off our race car to get the job done. Then when we finished testing and tuning we put all the parts back in the car including the engine that is now tuned.

Building your own engine DYNO can be difficult and confusing. This kit eliminates all the guess work, trial and error, so you can get testing right away. Engine DYNOs are very expensive and we wanted to change that. This simple design uses brakes on the rear axle to load the engine. Simple Cheap and effective.

If you like building race cars and racing engines and don’t want to spend money on DYNO time. Then this kit is for you! Fill out the Form at the bottom of this page to let us know more about what engines you want to work with and what power level you want to achieve.